REQUIRED TOOLS

  • Hose cutter



REQUIRED PARTS





BEFORE YOU START

  • Before you start, make sure the device is turned off and disconnected!
  • Unboxing



PROCEDURE

  • Place the Perfect Moose Jack on the counter.
  • Check the content of the installation kit.
  • Install the water-filtration.
  • Connect the water inlet hose to the water-filtration with the JG fitting 3/8 pushfit - 3/8M bsp.
  • Connect the Water booster pump
  • Cut the water inlet hose with a hose cutter to length and to install the shut-off tap.
  • Place the pressure reducer on the water inlet hose.
  • Screw the metal braided hose on the pressure reducer. (Do not overtighten!)
  • Remove the yellow tap from water inlet on the Perfect Moose Jack and connect the metal braided hose onto the Perfect Moose Jack.
  • Place a Y-piece on the wall drain pipe. Install the push-in fitting 1/4M on a drain end-cap and place to drain end-cap on the top of the Y-piece.
  • Connect the drain hose to the drain end-cap and lock the drain hose with the red 8mm fitting clips (for hot water).
  • Cut the drain hose to length with a hose cutter and connect the drain hose to the drain of the Perfect Moose Jack. Lock the drain hose with the red 8mm fitting clips (for hot water).
  • Insert the power cable in the powersocket and switch on the Perfect Moose.
  • Follow the first start procedure for finishing the installation of the Perfect Moose Jack