REQUIRED TOOLS

  • Screwdriver T10 Torx head
  • Screwdriver T25 Torx head
  • Allen key #5





BEFORE YOU START

  • Before you start, make sure the device is turned off and disconnected!



PROCEDURE

  • Unscrew the 2 screws of the pitcher holder base with a Torx T10 screwdriver. Remove the pitcher holder base from the Moose.

  • Unscrew the 2 screws on the front of the Greg housing with an Allen key #5.

  • Remove the 4 black screw caps from the back of the Moose.
  • Unscrew the 4 screws at the back of the Greg housing with a Torx T25 screwdriver.
  • Move the steam wand up.
  • Remove the Greg housing front from the Moose by holding the housing front with 2 hands.
  • Pull the housing to the front until it almost touches the side of the RFID holder.
  • Lift the housing upwards until it is above the RFID holder.
  • Pull the housing to the front to fit the steam wand through the slit.