REQUIRED TOOLS

• Screwdriver T10 Torx head
• Screwdriver T25 Torx head
• Allen key #5

BEFORE YOU START

PROCEDURE

• Remove the Jack housing back.
  

• Remove the pitcher holder (Jack or Epic Jack) from the Moose.

• Unscrew the 2 screws of the pitcher holder base with a Torx T10 screwdriver. Remove the pitcher holder base from the Moose.

• Unscrew the 2 screws on the front of the Jack housing with an Allen key #5.

• Unscrew the 4 screws on the back of the Jack housing with an Torx T10 screwdriver. 

• Move the steam wand up.

• Remove the Jack housing front from the Moose by holding the housing front with 2 hands.

• Pull the housing to the front until it almost touches the side of the RFID holder.

• Lift the housing upwards until it is above the RFID holder.

• Pull the housing to the front to fit the steam wand through the slit.