REQUIRED TOOLS

• Screwdriver T10 Torx head
• Screwdriver T25 Torx head
• Allen key #5

BEFORE YOU START

PROCEDURE

• Move the steam wand up to the top.

• Carry the Greg housing with 2 hands and fit the steam wand through the slit of the housing.
• Push the housing to the back. Take care that the housing doesn't touch the RFID holder.
• Move the housing downwards to fit the RFID holder through the housing.

• Push the housing backwards until it locks in the Greg housing back assembly. Check the alignment of the touchscreen in the housing! If needed, pull the touchscreen downwards with 2 fingers to align it in the housing of the Moose.
• Screw the 4 black T25 Torx screws in the back of the Moose and the 2 Hex #5 socket cap screws on the front of the housing.
• WARNING the tightening force of the screw is max 1Nm!

• Place the pitcher holder base on top of the RFID holder.
• Screw the 2 T10 Torx screws in the pitcher holder base. 

• Put pitcher holder (Greg or Epic Greg) on the pitcher holder base.
• Turn the pitcher holder until it is flush with the housing of the Moose. 

• Plug in the electrical cord and turn the Moose on.
• Check the calibration of the load cell
• Check all the valves in the manual testing menu