REQUIRED TOOLS

• Screwdriver T10 Torx head
• Screwdriver T25 Torx head
• Allen key #5

BEFORE YOU START

PROCEDURE

• Move the steam wand up to the top.

• Carry the Jack housing with 2 hands and fit the steam wand through the slit of the housing.

• Push the housing to the back. Take care that the housing doesn't touch the RFID holder.

• Move the housing downwards to fit the RFID holder through the housing.

• Push the housing backwards Check the alignment of the touchscreen in the housing! If needed, pull the touchscreen downwards with 2 fingers to align it in the housing of the Moose.

• Screw the 4 black T25 Torx screws in the back of the Moose and the 2 Hex #5 socket cap screws on the front of the housing.
  WARNING the tightening force of the screw is max 1Nm!

• Place the pitcher holder base on top of the RFID holder.

• Screw the 2 T10 Torx screws in the pitcher holder base.

•  Put pitcher holder (Greg or Epic Greg) on the pitcher holder base.

• Turn the pitcher holder until it is flush with the housing of the Moose.

• Carry the Jack housing with 2 hands to fit over the boiler part.

• Screw the 4 screws on the side of the Jack housing (back) with a Torx T25 screwdriver