REQUIRED TOOLS

• Screwdriver T10 Torx head
• Screwdriver T25 Torx head
• Allen key #5

REQUIRED PARTS

• 13106 - Touchscreen in holder

BEFORE YOU START

PROCEDURE

• Remove the touchscreen from the main-assembly by pulling on the 2 clips on the leftside of the screenholder.

• Gently unlug the screen cable from the touchscreen.

• Place the new touchscreen in holder back on the main-assembly and connect the screencable
• Upload the screen software.
  Attention, the software on the motherboard and touchscreen must be the same software verison.
• Close the Greg housing, attention check the alignment of the touchscreen in the housing!