REQUIRED TOOLS

• Screwdriver T10 Torx head
• Screwdriver T25 Torx head
• Allen key #5

BEFORE YOU START

PROCEDURE

• Remove the pitcher holder (Greg or Epic Greg) from the Moose.
  

• Unscrew the 2 screws of the pitcher holder base with a Torx T10 screwdriver. Remove the pitcher holder base from the Moose.

• Unscrew the 2 screws on the front of the Greg housing with an Allen key #5.

• Unscrew the 4 screws at the back of the Greg housing with a Torx T25 screwdriver.

• Move the steam wand up.
• Remove the Greg housing front from the Moose by holding the housing front with 2 hands.
• Pull the housing to the front until it almost touches the side of the RFID holder.
• Lift the housing upwards until it is above the RFID holder.
• Pull the housing to the front to fit the steam wand through the slit.