REQUIRED TOOLS
- Screwdriver T10 Torx head
- Screwdriver T25 Torx head
- Allen key #1.5
- Allen key #5
- Open ended spanner n°5
BEFORE YOU START
|
PROCEDURE
- When the steam wand drops to much downwards from the limit switch.
- Remove the plastic caps from the Igus carriage on cool touch steam pipe assembly.
- Loosen the nut (counterclockwise) with an open ended spanner n°5. Do not loosen the nut more than 30°!
- The Igus carriage can be tightened with an allen key #1.5. Do not overtighten the Igus carriage. Check the movement while adjusting by sliding the steam wand assembly up and down manually.
1 | 2 | 3 |
---|---|---|
![]() | ![]() | ![]() |
Front & back movement (Left hand side) | Front & back movement (Right hand side) | (Counter)-clock movement |
- After the adjustment of the steam wand assembly lock the nut again with an open ended spanner n°5
- Remove the plastic caps from the Igus carriage on cool touch steam pipe assembly.
- Access the service menu
- Go into 'Manual testing'.
Check the movement the steam wand assembly in the manual testing menu. Click on the button 'Bottom'.
The steam wand shut drop smoothly until it touches the pitcher holder.
- Click on the button 'Top' to move the steam wand upwards.
- Exit the menu.
- Close the housing.