REQUIRED TOOLS

• Screwdriver T10 Torx head
• Screwdriver T25 Torx head
• Allen key #5

REQUIRED PARTS

• 12891 - Touchscreen in holder

BEFORE YOU START

PROCEDURE

• Remove the touchscreen from the main-assembly by pulling on the 2 clips on the leftside of the screenholder.

• Gently unlug the screen cable from the touchscreen.

• Remove with a T10 screwdriver the 4 screws at the back of the touchscreen and remove the screen from the screenholder. 
  
• Replace the touchscreen by placing the new touchscreen in an angle from right to left in the screenholder.. ATTENTION, don't damage the copper-flatcable of the touchscreen! Tighten with a max force of 0.3Nm.

• Lock the touchscreen in the screenholder by softly tightening the 4 screws at the back of the touchscreen with a T10 screwdriver.
• Place the screen with screenholder back on the main-assembly and connect the screencable
• Upload the screen software.
• Close the Greg housing, attention check the alignment of the touchscreen in the housing!